Next: Background
Up: lab8b
Previous: Objective
Italicized parts were used in the previous lab.
- wire kit and breadboard
- MicroStamp11, docking module, and serial cable
- Laptop with ICC11 compiler and PMS91 loader
- one 7-segment LED display (LSD3221-11)
- seven 2.2 k-ohm resistors
- two 10 k-ohm resistor
- two buttons
- one LM660 quad op-amp IC
- two resistors () for op-amp buffer
- two 1n4007 diodes
- one 10 k-ohm trim potentiometer
- two additional resistors for diode clamp
circuit
- additional resistor for RC network
capacitor for RC network.
- four 1n4007 diodes
- LM7805 voltage regulator with heat sink
- 120-12 volt wall transformer
- power cord connector
- 1000 F electrolytic capacitor
- Zener Diode and 100-400 ohm resistor
- 0.1 F ceramic capacitor
Michael Lemmon
2009-02-01